Protein skimmers are arguably the most useful component of the modern saltwater aquarium. Oxygenating water, removing dissolved organics, and clarifying water all help our
closed systems imitate the pristine waters of the reef. Most protein skimmers are improperly tuned and only provide a fraction of the benefits. So if you are looking to buy a skimmer, or judge if yours is working right, here is a summary.
The basic idea behind a protein skimmer is to have the finest bubbles possible suspended in the water the longest time. This allows time for the dissolved waste to coat the bubble, rise to the top, and be removed. I will use the old counter current air-driven models as an example. At the bottom of the skimmer an airstone creates a current upwards. Near the top of the skimmer is an inlet for tank water, with the water exit at the bottom. The trick is to get the bubbles to remain suspended, but not be pushed out the bottom, by adjusting the amount of water flowing downwards. This allowed for the maximum coating of the bubbles, and maximum density of bubbles in skimmer.
Venturi skimmers are a way of injecting air into water. The idea is like that old straw trick we annoyed our parents with. Blow across a straw that is in a cup of water, and presto, you have a projectile spray and a waiter cleaning up a mess. Venturi inlets just reverse this and use a stream of water to draw air in. These are very effective, although you need to see that the design allows for the air/water mixture to remain in the skimmer tube until saturated. This includes swirling the mixture to maximize tube length, sending it through a byzantine maze to maximize space, or utilizing the counter current design mentioned above.
Venturi designs have improved by reducing the size of the bubbles injected, as in the needle wheel and downdraft technology. Needle wheel skimmers have air injected before the pump where the bubbles are chopped finely by the custom impeller. These are very effective and produce a very dry foam. Downdraft skimmers send the air/water mixture through a tube of bio-balls to break apart the bubbles and maximize contact time.
When you have your skimmer set up, you will want to adjust it for your tank. Overall, adjustment will probably be a matter of raising or lowering the air/water mixture level in the skimmer. If you run your skimmer and you are getting a brown residue in the tube but not in the cup, you need to raise the level of the air/water. This is done by either opening the valve to let more water come in from the pump, or if your pump is maxed out then you need to restrict the amount of water coming out of the skimmer. If you are getting a lot of clearish, watery looking foam in the cup, then you can lower the level of the water/air mixture so that the foam takes longer to build up then overflow.
Please make small adjustments at a time, and let your skimmer run for a few hours before adjusting more. This is important because you skimmer will skim differently depending on the surface tension of the water. Depending on your feeding schedule or the time of day you skimmer may be making larger bubbles one minute then foaming over the next. Even the oils on your hand can make the water tension fall and the skimmer will not skim for a few minutes or hours.
Good luck and enjoy your tank,
Intrinsic Reef Design
No comments:
Post a Comment